1. Locate and peel off the label on top of the cartridge. Upon peeling the sticker, you will see three tiny holes. These holes are too small even for a syringe’s needle.
2. Use a thumb drill for drilling each hole a bit larger.
3. Fill the syringe with about 6 cc of color ink.
4. Insert the syringe’s needle into the hole you just drilled. Push down the plunger to inject the ink slowly. Make sure the ink doesn’t overflow.
The cartridge is now ready for use. Some people replace the top label, but you don’t have to as it will not affect the printing quality.
5. Replace the cartridge in the printer and run two or three cleaning cycles.
PG Series (Black)
1. Locate the letter “B” engraved on the cartridge.
2. Drill a small hole using the thumb drill into the dimple just beneath the engraved letter.
3. Fill the syringe with 20 cc of black ink.
4. Slowly inject the black ink into the hole you drilled. You can leave the hole open as there is no need to seal it.
5. Install the cartridge in the printer and run two or three cleaning cycles.
No comments:
Post a Comment