1. Remove the batteries to determine if they have been properly installed in the unit.
2. Install fully charged or new batteries to ensure that the unit is ready for operation. The batteries can be checked with a voltmeter or battery tester to make sure they have a maximum charge.
3. Reset the unit’s internal processor by turning off the unit and turning it on again. Also, the battery unit can be removed for five to 10 seconds to allow the capacitor to discharge.
4. Select the “Auto Level Mode” to make sure the unit is operating properly and will provide a proper self-level measurement.
5. Use a clean, dry cloth to make sure the laser emitter is clear of all dust and debris. This will ensure that a proper level is achieved.
No comments:
Post a Comment